+447464132630
DPA MMP-B Preamp, low cut and high boost
Preamplifier with low cut and high boost filters.
Combine this preamp with any capsule in the DPA d:dicate Recording Microphones series.
No relevant currency found
Preamplifier with low cut and high boost filters.
Combine this preamp with any capsule in the DPA d:dicate Recording Microphones series.
| Output connector: | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: signal - phase |
|---|---|
| Low-cut frequency, -3 dB: | 50 Hz |
| Noise with shorted input, A-weighted: | 1.1 µV |
| Output voltage, RMS: | > 1.8 V |
| Output voltage, peak: | > 2.5 V |
| Type of electronic circuit: | Active |
| THD@1VRMS, 1kHz: | < 0.5 % |
| Dynamic range: | 124 dB |
| Switchable filters: | High boost: +4 dB at 8 kHz. Low cut: First order filter, below 120 Hz |
| Output impedance: | < 150 ohm |
| Output balance principle: | Signal balanced |
| Common Mode Rejection Ratio (CMRR): | > 40 dB |
| Power supply (for full specifications): | 48 V Phantom power (± 4 V) |
| Current consumption: | 4.5 mA |
| Color: | Matte black |
| Weight: | 38 g (1.3 oz) |
| Diameter: | 19 mm (0.75 in) |
| Length: | 99 mm (3.9 in) |
| Cable drive capability: | 100 m (328 ft) |
| Temperature range: | -40 °C to 45 °C (-40 °F to 113 °F) |
| Relative Humidity (RH): | Up to 90% |
Explore our best selection
SIGN UP FOR OUR NEWSLETTERS
By providing your e-mail, you are agreeing to our privacy policy. Your information will never be shared and you can unsubscribe at any time.
By providing your e-mail, you are agreeing to our privacy policy. Your information will never be shared and you can unsubscribe at any time.
